 |
 |
 |
 |
 |
Accessories - Tube Fabrication
- Tube Collector Table - CT
- Tube Trim Saw - TTS
- Tube Uncoiler - USB-2-2C
- Tube Uncoiler - USB-2-2CBP
- Tube Uncoiler - USB-2-4C
- Tubing Uncoiler - USB-2-6C
Hairpin Benders
- AHBH - Automatic Hopper Fed, Long
- AHBM (4 tube)
- AHBM/SL - Bender/Straightener
- AHBQ - Automatic Mandrel Type
- AHBQ/SL - Bender/Straightener
- AHBV (6 tube)
- AHBV/SL - Bender/Straightener
- AHBVB (6 tube, belt fed)
- HBPA (Hand-Fed, Power Assist)
- HBVQ (Hand-Fed, Power Assist)
- MB (Manual Bender)
- Powered Tube Benders - PB-2
Header Machinery
Return Benders
- RBQ - Return Bender
- RBV - Return Bender
- REXQ - Combination Bender
- RSL - Return Bend Sizer & Ring Loader
Tube Straightener/End Forming
- STMBC - End Form / Tube Straighter (Belt Fed)
- STMC - End Form / Tube Straighter (Belt Fed)
- Saw Cutoff - STQS
- Tube End Former - STQC-4W
- Tube Straightener - STQC
- Tube Straightener - STVC
Uncoiler
Tube Trim Saw - TTS
Click picture to enlarge
The Model TTS-1 Tube Trim Saw consist of a stand mounted Two (2) HP-3400 RPM precision saw motor with saw blade and blade guard, pillow-block bearing mounted pivot arm with tube clamp, and motor starter with off-on switch. There are adjustments for tangent leg length and travel of the tube clamp pivot arm.
The operation is as follows: After clamping the bend, the operator then rotates clamped bend into the motorized circular saw, which trims the bend to the pre-set tangent leg length. It is generally recommended to make a bend at both ends of the tube, since this method results in minimal material usage.
Interchangeable tooling is available for the TTS-1 Tube Trim Saw, which will allow the sawing of return bends and dual 90 degree crossover type bends.
